2003 Lexus GS 300 PARK/ NEUTRAL POSITION SWITCH MALFUNCTION
download Park/neutral position switch detects the shift lever position and sends signals to the ECM. The ECM receives signals (P, R, N, D, 4, 3, 2 and L) from the park/neutral position switch. When the...
View Article1994 Oldsmobile Eighty-Eight Royale Crankshaft Position Sensor: Service and...
download Remove or Disconnect: 1. Disconnect negative battery cable 2. Remove serpentine belts from crankshaft pulley 3. Properly raise and support vehicle 4. Remove right front tire and wheel assembly...
View Article1996 Ford Aerostar/Ranger/Explorer Camshaft Position (CMP) Sensor REMOVAL AND...
download CAUTION: Syncro Positioning Tool T95T-12200-A (3.0L, 4.0L) or T96T-12200-A (5.0L) must be obtained prior to installation of the replacement synchronizer assembly. Failure to follow this...
View Article2002 TOYOTA TACOMA Crankshaft Position Sensor ”A” Circuit Malfunction
download CIRCUIT DESCRIPTION The crankshaft position sensor, which detects the engine speed and crankshaft angle signal (NE signal), has been installed on the oil pump body. The NE signal plate has 34...
View Article2004 Ford Explorer Crankshaft Pulley and Crankshaft Seal
download 1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-00. 2. Remove the cooling fan and the cooling fan shroud. For additional information,...
View Article1991 Ford Thunderbird Crankshaft Position Sensor Service and Repair
download 1. Disconnect the negative battery cable. 2. Disconnect the crankshaft sensor electrical connectors from the engine wiring harness. 3. Raise vehicle and support properly. 4. Remove the upper...
View Article1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation
download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to...
View Article1995 Ford Windstar Engine Front Cover REMOVAL AND INSTALLATION
download Engine Front Cover If the engine front cover (6019) is being removed to check timing chain deflection, refer to Timing Chain Deflection Procedure as outlined in Section 03-00. SPECIAL SERVICE...
View Article1998 Ford Windstar Camshaft Position (CMP) Sensor REMOVAL AND INSTALLATION
download CAUTION: Prior to removal of the camshaft position sensor (CMP sensor) (12126) , set cylinder No.1 to zero degrees top dead center (TDC) of compression stroke. Then note the position of the...
View Article1995 Ford Mustang Camshaft Position (CMP) Sensor Removal Installation
download 1. Disconnect battery ground cable (14301) . 2. Disconnect fuel charging wiring (9D930) from distributor stator (12A112) (camshaft position sensor). 3. Remove stator camshaft position sensor...
View Article
More Pages to Explore .....